No soliciting permitted.

Register Log in

Door panel removal for light kit installation

HerrLynch

Member
Messages
44
Reaction score
15
Points
8
Location
Augusta, GA
Hello all, I'm hoping someone can give me some info on how to remove the door panels for the front and rear doors to install my aftermarket mood lighting kit I ordered...actually arriving today. The modules to control the fiber strands just need a power source to tap into, which I figure I could use probably the wires for the power windows. Could someone point me in the right direction or to maybe a thread that has already started? thanks
 
Looking to cover or replace the KIA emblems on your Telluride? Look no further than right here in our own forum store - where orders are shipped immediately!

BPS725

New member
Messages
11
Reaction score
21
Points
3
Hello all, I'm hoping someone can give me some info on how to remove the door panels for the front and rear doors to install my aftermarket mood lighting kit I ordered...actually arriving today. The modules to control the fiber strands just need a power source to tap into, which I figure I could use probably the wires for the power windows. Could someone point me in the right direction or to maybe a thread that has already started? thanks
Do you have pictures? What product did you buy?
 

HerrLynch

Member
Messages
44
Reaction score
15
Points
8
Location
Augusta, GA
Do you have pictures? What product did you buy?
I bought this product Ambient Light Car Atmosphere Light Lamp APP Control 64 colors DIY Soft Refit Optic Fiber Band For Ca
Mainly because watching the video, to install lights in the back, the modules are wireless controlled instead of having to run wires everywhere. You just need a power source (power and ground) for each module.
Herr - this video has a nice walkthrough on removing the door panels:
Thanks Mitch, like to have a wiring diagram
 
Top